Vehicle Recalls
5,507 recalls from vehiclerecalls.gov.au
Cars, trucks, motorcycles, trailers, and caravans affected by safety defects.
Vehicle Recalls results
REC-003049
active0 TRIUMPH Tiger 1050, Tiger 1050 (ABS), Sprint ST, Sprint ST (ABS)
A potential problem exists with restricted lateral movement of the sliding carriage of the fitted top rack, which could lead to reduced stability of the motorcycle if ridden at speeds in excess of 130km/h.
Motorcycle
28 Nov 2007
REC-003050
active0 MITSUBISHI FUSO Canter FE7
A potential fault in the glow plug relay, which is part of the engine pre-heating system, may cause the coil to overheat and possibly short circuit.
Heavy Vehicle
27 Nov 2007
REC-003064
active0 Eagle-Wing Various
Clutch and front and rear brake shoes may contain asbestos.
Motorcycle
27 Nov 2007
REC-003046
active0 Ford UQ & US Explorer, F Series
In certain circumstances the underhood speed control deactivation switch mounted on the brake master cylinder may leak and brake fluid contamination in the electrical connector may cause the wiring to overheat, smoke, or burn. This condition may occur either when the vehicle is parked or when it is being operated, even if the speed control is not in use.
Light Vehicle
22 Nov 2007
REC-005198
active2006-2007 KTM Sport motorcycle—Retrofit
On affected models, during use the 1/4 turn filler cap may leak from the sealing area of the filler cap and fuel tank.
Motorcycle
13 Nov 2007
REC-005197
active2005 JAYCO Caravan Jack
The existing labelling of the Jack does not fully comply with the requirements of the mandatory consumer product safety standard for vehicle jacks based on Australian/New Zealand Standard AS/NZ 2693:2003 - Vehicle Jacks ("vehicle jack safety standard").
Caravan/Motorhome
12 Nov 2007
REC-000389
active0 Hino Dutro RK1JSLL, Dutro RK1JSML
The air pressure warning light (equipped with as Visible Indicator regulated in ADR 35/01 S.5.2') was not so designed that, as a check of function, it operates when the ignition key switch is turned from the 'START' position and it must not operate after the return of the ignition switch to the 'ON' position. The condition is not in compliance with the regulation 'ADR 35/01 S.5.2.6'.
Heavy Vehicle
8 Nov 2007
REC-003044
active0 KAWASAKI KL650A, KL650E
There is a possibility that an incorrect tightening of the muffler mounting bolts may cause the bolts to unscrew by vibration, which may result in the muffler falling off and creating a risk to rider safety.
Motorcycle
8 Nov 2007
REC-000079
active0 BMW G650 Xchallenge
In isolated instances, fuel lines suffered incipient damage in the course of the manufacturing process. Lines damaged in this way could develop leaks soon after customers start using their motorcycles. There are two known sets of symptoms: - Fuel leaking through the fabric inlay at the ends of the lines; and - Fuel line develops a crack.
Motorcycle
7 Nov 2007
REC-000107
active0 BMW G650 Xchallenge
Some G650 Xchallenge motorcycles left the factory with the wrong circlip installed on the left-hand side of the rear wheel-bearing guide. The result can be that this circlip rubs against the spacing bushing. The particles of metal removed by friction can penetrate the wheel bearing and cause failure. There is also the possibility of incorrect sensor signals causing the ABS to malfunction. If this happens the ABS warning light comes on, alerting the rider to the situation. Even under these circumstances, the brakes remain fully available to slow the motorcycle.
Motorcycle
7 Nov 2007
REC-003038
active0 Ford Falcon BFII E-Gas Falcon
The affected LPG tanks may have a service valve hand tap that could fail causing LPG to leak from the hand tap spindle.
Light Vehicle
2 Nov 2007
REC-003043
active0 Mazda Mazda BT-50 4x4 automatic, Hi Rider 2WD
The incorrect Compliance Plate Approval (CPA) number was embossed on the compliance plate.
Light Vehicle
30 Oct 2007
REC-003042
active0 FREIGHTLINER Argosy, Century S/T & Columbia
Certain Douglas Autotech steering columns may have been manufactured without two welds which could cause the column to fatigue and fracture over time, thereby allowing the steering wheel to progressively move out of its normal operating position.
Heavy Vehicle
29 Oct 2007
REC-003035
active0 Mercedes-Benz Type 1728, 1830 & 1830LE
Investigations by the manufacturer have shown that there is a possibility the thread profile for the rear axle hub retaining nut may be out of specification, thereby decreasing the retention force acting on the hub nut. A loose hub nut could compromise the integrity of the hub assembly.
Light Vehicle
24 Oct 2007
REC-003034
active0 FREIGHTLINER Columbia, Century, Argosy
A small number of seat riser boxes were supplied by Isringhausen which do not fully comply with ADR requirements for structural strength. Should a vehicle with a faulty seat riser be involved in an accident the seat and occupant may not be adequately restrained and could detach from the floor of the cab.
Heavy Vehicle
23 Oct 2007
REC-003041
active0 Iveco EuroCargo Tector ML100, ML230
Some vehicles may experience heater tap coolant leaks. These leaks can ingress into electrical connectors via the wiring harness.
Heavy Vehicle
23 Oct 2007
REC-003040
active0 Toyota Hiace Van TRH201/TRH221 & Commuter Bus TRH223
There is a possibility that the fuel pump may wear prematurely due to insufficient clearance between the coils of the internal motor. If vehicle operation continues in this condition, there is a possibility that the fuel pump could cease to function. In the worst case scenario the fuel pump motor may not operate, preventing the engine from restarting or resulting in the engine stalling while driving.
Light Vehicle
22 Oct 2007
REC-003045
active0 Ford Falcon BFII
The affected LPG tanks may have a service valve hand tap fitted with undersized O-rings.
Light Vehicle
18 Oct 2007
REC-003037
active0 Ford Falcon BFII E-Gas Falcon
The affected LPG tanks may have a service valve hand tap fitted with undersized O-rings.
Light Vehicle
18 Oct 2007
REC-003033
active0 SUZUKI Liana 1.6, Liana 1.8 manual transmission
Due to the shape of the gearshift select lever cable retainer clip, there is a possibility that the clip may impact the gearshift select lever bracket if excessive lateral force is applied when shifting to first gear. If a high frequency of impacts is experienced, the clip may dislodge or even break and the cable may detach rendering the gearshift slect lever inoperable.
Light Vehicle
16 Oct 2007
REC-003032
active0 Toyota Hilux 2x4, 4x4
There is a possibility that the vehicle's engine hood (bonnet) inner panel may crack in the proximity of the striker (part of the retaining latch mechanism) due to prolonged driving on corrugated road surfaces. If vehicle operation continues in this condition, the fracture will extend around the welds of the striker resulting in increasing movement and rattling noise.
Light Vehicle
12 Oct 2007
REC-003031
active0 Toyota Hilux 4x4
Investigations reveal that when Hilux 4x4 GGN25 and KUN26 model vehicles are fitted with a Toyota genuine bullbar (equipped with additional turn signal lights) and are operating a trailer, the vehicle wiring and flasher relay unit capacity is insufficient to operate all the turn signal lamps for the hazard warning function. Individual turn signal lamps (left or right) are not affected.
Light Vehicle
12 Oct 2007
REC-003030
active0 TRIUMPH Rocket III, Rocket III Classic
Engine poor/erratic idling quality and stalling. Recall is to download a revised calibration into the engine management systems as well as carry out a range of checks and adjustments.
Motorcycle
5 Oct 2007
REC-000545
active2001-2005 Honda VFR800
Under certain conditions, when owners fit after-market head-light bulbs, the ground wire terminals inside the sub-harness connector may overheat and melt the wiring connector, causing loss of power to various circuits.
Motorcycle
3 Oct 2007