Skip to content

Data sourced from official Australian recall publishers. RecallAU is an independent service, not a government website.

recallau
🚗

Vehicle Recalls

5,569 recalls from vehiclerecalls.gov.au

Cars, trucks, motorcycles, trailers, and caravans affected by safety defects.

Vehicle Recalls results

vehicle

REC-003159

active

0 SUBARU Tribeca

FHI (Subaru Japan) have determined that the front lateral link in the rear suspension of 07MY, 08MY and certain 09MY Tribeca vehicles may crack and if left unchecked could, in time, break. There is a safety risk associated with this condition. If the lateral link were to break the rear suspension would experience lack of 'toe' control and the driver may consequently lose control of the vehicle.

Light Vehicle

18 Nov 2008

vehicle

REC-003132

active

0 JAGUAR XF

A concern has been identified with the fitting process used in vehicle manufacture in relation to both rear seat belt D-loops on a number of 2009MY Jaguar XF vehicles. A minority of vehicles built up until VIN R22438 may have had seat belt D-loops fitted where the D-loops may not freely rotate. The seat belt may not run freely when the rear seat belts are being pulled out and, should a vehicle suffer a moderate to heavy frontal impact, the rear seat occupants may not be fully restrained.

Light Vehicle

17 Nov 2008

vehicle

REC-004847

active

0 PRB Birkin S3

Failure of two cast alloy rear suspension uprights have been reported. These failures resulted in detaching of the main wishbone mounting, and/or toe adjuster mounting from the main body of the rear upright. Fatigue related cracks have also been found in the body of the uprights. Both of these failures reported resulted in loss of vehicle control due to sudden loss of rear wheel location.

Light Vehicle

14 Nov 2008

vehicle

REC-003153

active

0 KAWASAKI KL650E8F

The turn signal mounting stalk can break easily, causing the turn signal light to fail to clearly indicate the operator's intention to turn.

Motorcycle

10 Nov 2008

vehicle

REC-003157

active

0 Western Star 4900, 6900

Certain slack adjusters on SISU may have been machined with a counter-bore in the slacker adjuster housing that reduced the material thickness between the worm wheel opening and the worm shaft opening

Heavy Vehicle

10 Nov 2008

vehicle

REC-003158

active

0 SUBARU Liberty GT, Liberty GT spec. B, Liberty GT spec. tuned by STI, Impreza WRX,

The vehicles may have been produced with the turbo charger oil supply pipe deformed due to misalignment during the assembly process. If the pipe is deformed, vibration experienced during normal driving could result in a crack developing in the pipe over time, causing an engine oil leak.

Light Vehicle

10 Nov 2008

vehicle

REC-005282

active

0 CITROEN C4 Picasso

Insufficient holding of the vehicle (only one wheel locked).

Light Vehicle

6 Nov 2008

vehicle

REC-003152

active

0 BUELL XB12XT

The compnay has determined that windshields on these model motorcycles, built during the above date range and fitted with a rubber-mounted nut (part numbr M025.1AV), may become dislodged and allow the windshield to either strike or distract the rider while the vehicle is being ridden at high speed.

Motorcycle

31 Oct 2008

vehicle

REC-003156

active

0 CITROEN C2, C3 & C3 Pluriel

Suspension arm nuts need re-tightening.

Light Vehicle

28 Oct 2008

vehicle

REC-003155

active

0 KAWASAKI VN900B8F, VN900C8F

The fuel filler flange on the fuel tank is incorrectly formed, leaving a section tht is unsealed. This may allow the fuel to leak if the fuel reaches the unsealed section in certain situations such as a high fuel level or the vehicles inclination angle, etc. This may create the potential risk of fire or explosion.

Motorcycle

27 Oct 2008

vehicle

REC-003149

active

0 Man TGA, TGS, TGX

A potential for uneven braking (side to side) due to a software error within the EBS control unit.

Heavy Vehicle

24 Oct 2008

vehicle

REC-003148

active

0 SUZUKI Vitara JB

Under extreme exposure levels to engine oil, contained in the combustion blow-by gas, the material compound of the Intercooler Outlet Pipe Insulator may swell and, as a result, dislodge from the throttle body. After extended periods in this dislodged condition, the improper ratio of air/fuel mixture may cause excessive deposition of carbon particulate in the Diesel Particulate Filter, and in an extreme instance may cause the Diesel Particulate Filter to catch fire.

Light Vehicle

23 Oct 2008

vehicle

REC-003154

active

0 MITSUBISHI RG Colt

On affected vehicles, the front door glass run channel (left and/or right) may have been incorrectly installed and as a result, there is the potential that when the front door glass is operated, it may disengage from the guide rail sash. This creates the possibility of contact with the door unlock rod and may result in the door opening.

Light Vehicle

21 Oct 2008

vehicle

REC-003147

active

0 Honda Jazz

During the manufacturing process, damage may have occurred to a joint in the handbrake lever assembly mechanism. Continued use may cause sufficient wear for the joint to detach and make the handbrake assembly unserviceable.

Light Vehicle

20 Oct 2008

vehicle

REC-003151

active

0 CHRYSLER 300C, 300C Touring

The rear axle hub nuts (RWD models) or front and rear axle hub nuts (AWD models) on the vehicles may loosen and allow the half shaft to disengage from the wheel hub. This could cause the vehicle to lose power and result in loss of steering capabilities.

Light Vehicle

8 Oct 2008

vehicle

REC-003150

active

0 KAWASAKI KLX250T9F

The eligible units have been supplied with a mounting bracket and side reflectors that do not comply with Australian Design Rules.

Motorcycle

3 Oct 2008

vehicle

REC-003144

active

0 Mercedes-Benz Vito 639

Due to a faulty metallurgical process the hose fitting on the left rear park brake cable may detach and cancel the holding effect of the handbrake. This can also occur after the vehicle has been parked.

Light Vehicle

1 Oct 2008

vehicle

REC-003145

active

0 YAMAHA MT01, FZ1-N

There is a possibility that the rear view mirror may crack while riding. In the worst case, the mirror may not have enough strength against vibration in the long term, which may cause the mirror head to separate from the mirror stem.

Motorcycle

26 Sept 2008

vehicle

REC-003143

active

0 MITSUBISHI 380

There is the potential in the event a vehicle with a full tank of fuel is involved in a severe collision, that the LHR fuel tank retaining strap bracket may fail allowing the fuel tank to dislodge resulting in the possibility of a fuel leak.

Light Vehicle

24 Sept 2008

vehicle

REC-003142

active

0 LAND ROVER Freelander 2 Diesel

Condensation from the air conditioning evaporator mounted in the HeVAC unit can come into contact with the control circuitry for the additional electric booster heater; and a short circuit may result. This normally results in draining of the battery which eventually will go flat. This may lead to a non start situation. Additionally the short circuit may lead to a distinct smell from hot and/or melted components which in extreme circumstances may develop in to a fire in the interior of the vehicle. All of these symptoms can occur when the vehicle is in use or parked and unattended.

Light Vehicle

23 Sept 2008

vehicle

REC-003182

active

0 LAND ROVER Freelander 2

Condensation from the air conditioning evaporator mounted in the HeVAC unit can come into contact with the control circuitry for the additional electric booster heater; and a short circuit may result. This normally results in draining of the battery which eventually will go flat. This may lead to a non start situation. Additionally the short circuit may lead to a distinct smell from hot and/or melted components which in extreme circumstances may develop in to a fire in the interior of the vehicle. All of these symptoms can occur when the vehicle is in use or parked and unattended.

Light Vehicle

22 Sept 2008

vehicle

REC-003139

active

0 Mercedes-Benz Sprinter 906

Due to irregularities in the axle hardening process it is possible micro-fissures may develop in the axle which could lead to eventual failure and loss of drive power.

Light Vehicle

19 Sept 2008

vehicle

REC-003140

active

0 FREIGHTLINER Argosy, CL112, CST120 & CL120

It is possible that standard bolts rather than metric bolts may have been used in production to attach the brake caliper to the anchor plate at each wheel assembly. Incorrect bolts may not provide sufficient clamping force between the caliper and another plate, which could in turn lead to reduce brake effectiveness and increased risk of accident.

Heavy Vehicle

19 Sept 2008

vehicle

REC-003137

active

0 Mercedes-Benz Passenger Car Type 215, 216, 221, 230

Due to an incomplete soldering process during manufacture, certain electrical connections on the circuit boards of the ABC body acceleration sensors may trigger random sprung mass vibrations at the front axle of the vehicle. This in turn could influence driving stability and operational safety. In some cases a warning message may also be displayed in the instrument cluster.

Light Vehicle

19 Sept 2008

← PreviousPage 152 of 233Next →