Vehicle Recalls

0 MITSUBISHI UG Nimbus

The fuel tank upper panel may crack as a result of expansion and contraction of the fuel tank which occurs due to internal pressure changes. In the worst case fuel may leak from the crack when the fuel tank is full.

0 MITSUBISHI Magna and Verada

There is a possibility that the electrtical wiring harness for the fuel pump and fuel gage assembly may become damaged on some vehicles due to insufficient clearance to the underbody structure. This could cause the ignition switch fuse to blow.

1999-2000 Ford Explorer

The subject vehicles have a powertrain control module (PCM) that may allow the vehicle to exceed the design intent top speed. At these extreme speeds, the vehicle may be capable of exceeding the speed rating of the tyres.

0 SUBARU Outback, Liberty

Possible fuel tank leakage from cracked seam.

0 LAND ROVER Range Rover and Discovery Series II

Water can ingress into the automatic gearbox breather pipe causing the park lock function to corrode and become inoperative, and could lead to the vehicle rolling away.

0 PEUGEOT 306

The power brake vacuum pump drive pin may become defective under extreme and continuous braking operation resulting in loss of vehicle braking.

0 Toyota Dyna

Due to insufficient strength of the centre support bearing housing on the propeller shaft, the bearing housing may possibly break under frequent hard acceleration from low speed.

0 Kenworth Various

Potential fatigue cracking in steer arms.

0 Ford Explorer

0 LAND ROVER Discovery Series 11

The ACE system high pressure hose may fracture and leak fluid due to the absence of an attenuator spring within the hose assembly.

0 YAMAHA XV1600A/L

If the bolts holding the exhaust system become loose, the bracket holding the mufflers can break resulting in mufflers falling loose from the motorcycle. This can damage or pull loose the rear hydraulic brake hose, causing loss of rear brake performance.

0 DUCATI 748,916,996

The mounting brackets could fracture or break, which could result in a loss of steering and control of the motorcycle compromising the rider's safety.

0 STERLING Various

Potential defect with the lower steering column pitch bolt torque.

0 FREIGHTLINER FLC112

Defect may exist with the Haldex Park Brake Valve.

0 FREIGHTLINER FLN Business Class

The brake piston rod that activates the service brakes may bend and fracture, causing a loss of brakes.

0 STERLING AT, LT

TRW tie rod ends may wear prematurely.

0 BMW E53 X5

Due to a production fault it is possible that the upper and lower part of the steering column may not have been assembled correctly which could result in the steering shaft becoming separated thus causing total loss of steering.

0 Daewoo Nubira

The outlet pipe of the fuel filter may bend; and also the right angle joint of the fuel feed tube may split, resulting in leaking fuel with a possibility of fire.

0 Scania K & L Chassis

Cable ducting has sharp edges that can damage electrical cables resulting in an electrical short circuit.

0 BMW F650 GS, F650 GS Dakar

The bracket on which the rear brake caliper rests may bend which could result in damage to the threaded brake line connection and a leak at the rear caliper resulting in failure of the rear brake.

0 MOTO GUZZI Californian EV and Special

Possibility of loosening or breakage of spokes in the rear wheel.

0 Western Star 24-DL Tie rod end

Defective drag link and ball socket steering components have not undergone correct hardening procedures during manufacture and thus can wear prematurely. This can lead to the components separating with resultant loss of steering control.

0 PEUGEOT 206 GTI

A possibility exists that vehicle braking imbalance may occur due to incorrect specification tyres fitted to the vehicle (Continental 195/55R15) which do not comply to the vehicle ADR approvals.

0 BENTLEY Arnage

Either of the flexible hoses carrying fuel between the engine and the fuel cooler, and the engine and the body can leak.