Search Recalls
Search by VIN, keyword, make, or filter by recall type, year, and vehicle category.
Search results
5,459 recalls found
REC-003055
active0 Ford WQ Fiesta, VM Transit
The engine installed in affected vehicles may be fitted with a front end accessory drive belt that could delaminate and result in premature failure.
Light Vehicle
10 Dec 2007
REC-000245
active0 DUCATI Hypermotard 1100 & 1100 S
Failure of the number plate holder support.
Motorcycle
10 Dec 2007
REC-003056
active0 Daf Euro 4 CF
If the independent trailer handpiece is actuated while the vehicle is in cruise control, the cruise control will not cutout and the engine will continue driving. After the trailer brake is released the vehicle will also accelerate back to its original setting. The cruise control should disengage when the independent trailer brakes are operated.
Heavy Vehicle
6 Dec 2007
REC-003048
active0 Honda Legend
Potential fluid loss from a power steering feed hose. The cause of the power steering hose fluid loss is unexpectedly high heat deterioration, causing a corresponding loss of material flexibility and durability. Fluid loss may result in an increase in steering effort, smoke from fluid contacting hot exhaust components and, in the worst case, fire.
Light Vehicle
5 Dec 2007
REC-000246
active0 DUCATI 1098, 1098 S, 1098 Tricolore
Engine stalls at idle, which could endanger rider safety. Problem to be fixed by downloading new software to the engine control unit.
Motorcycle
3 Dec 2007
REC-003051
active0 CHRYSLER Jeep Grand Cherokee SRT8, Jeep Commander, Dodge Nitro, Jeep Wrangler
Investigations have shown that the EBC module may have been programmed with an incorrect software version. It is possible under certain conditions that a momentary delay in braking could occur when coasting up hill. This could potentially increase the vehicle's stopping distance.
Light Vehicle
30 Nov 2007
REC-000685
active0 JAYCO Vans
Depending on the axle and suspension type, specific vans that have been manufactured by Jayco Corporation Pty Ltd may require a change to the jacking point of the van.
Caravan/Motorhome
30 Nov 2007
REC-003047
active0 LEXUS IS250, GS300
During the manufacture of two fuel pipes located on the engine's fuel delivery manifold, high stress areas may have been created in the pipes. Combined with other factors such as continual high fuel pressure pulsations and the presence of natural corrosive agents in the fuel a fracture may form over time.
Light Vehicle
29 Nov 2007
REC-003052
active0 HYUNDAI i30
The spare wheel in the FDi30 SX and SLX variants are fitted from factory with a steel wheel and 185/65 R15 tyre. The road wheels on the SX variant are 195/65R15 steel wheels and the SLX is equipped with 205/55R16 alloy wheels. In order to comply with the Australian market regulations, all the affected vehicles will require the 15' spare steel wheel to have two warning labels attached to the outer face of steel rim. The warning labels indicate the spare wheel is for temporary use only at a maximum speed of 80KPH and the road wheel should be replaced with correct size wheel to match the remainder on the vehicle as soon as possible.
Light Vehicle
29 Nov 2007
REC-003054
active0 MITSUBISHI ZE & ZF Outlander
The front edge of the older design genuine accessory carpet mat overlaps the arc of travel of the accelerator pedal. This creates the potential for interference of the carpet mat with the accelerator at the full throttle position.
Light Vehicle
29 Nov 2007
REC-001551
active0 ISUZU N5 NPR
A limited number of trucks have an incorrectly welded fluid coupling.
Heavy Vehicle
28 Nov 2007
REC-003049
active0 TRIUMPH Tiger 1050, Tiger 1050 (ABS), Sprint ST, Sprint ST (ABS)
A potential problem exists with restricted lateral movement of the sliding carriage of the fitted top rack, which could lead to reduced stability of the motorcycle if ridden at speeds in excess of 130km/h.
Motorcycle
28 Nov 2007
REC-003053
active0 MITSUBISHI NS Pajero
A number of NS Pajero vehicles have been manufactured with the incorrect nuts used to retain the front R/H drive shaft and both front and rear propeller shafts. The threaded portion of the nut may deform on tightening, allowing the nut to become loose in operation.
Light Vehicle
28 Nov 2007
REC-003050
active0 MITSUBISHI FUSO Canter FE7
A potential fault in the glow plug relay, which is part of the engine pre-heating system, may cause the coil to overheat and possibly short circuit.
Heavy Vehicle
27 Nov 2007
REC-003064
active0 Eagle-Wing Various
Clutch and front and rear brake shoes may contain asbestos.
Motorcycle
27 Nov 2007
REC-003046
active0 Ford UQ & US Explorer, F Series
In certain circumstances the underhood speed control deactivation switch mounted on the brake master cylinder may leak and brake fluid contamination in the electrical connector may cause the wiring to overheat, smoke, or burn. This condition may occur either when the vehicle is parked or when it is being operated, even if the speed control is not in use.
Light Vehicle
22 Nov 2007
REC-005198
active2006–2007 KTM Sport motorcycle—Retrofit
On affected models, during use the 1/4 turn filler cap may leak from the sealing area of the filler cap and fuel tank.
Motorcycle
13 Nov 2007
REC-005197
active2005 JAYCO Caravan Jack
The existing labelling of the Jack does not fully comply with the requirements of the mandatory consumer product safety standard for vehicle jacks based on Australian/New Zealand Standard AS/NZ 2693:2003 - Vehicle Jacks ("vehicle jack safety standard").
Caravan/Motorhome
12 Nov 2007
REC-003044
active0 KAWASAKI KL650A, KL650E
There is a possibility that an incorrect tightening of the muffler mounting bolts may cause the bolts to unscrew by vibration, which may result in the muffler falling off and creating a risk to rider safety.
Motorcycle
8 Nov 2007
REC-000389
active0 Hino Dutro RK1JSLL, Dutro RK1JSML
The air pressure warning light (equipped with as Visible Indicator regulated in ADR 35/01 S.5.2') was not so designed that, as a check of function, it operates when the ignition key switch is turned from the 'START' position and it must not operate after the return of the ignition switch to the 'ON' position. The condition is not in compliance with the regulation 'ADR 35/01 S.5.2.6'.
Heavy Vehicle
8 Nov 2007