Search Recalls
Search by VIN, keyword, make, or filter by recall type, year, and vehicle category.
Search results
5,459 recalls found
REC-003207
active0 Kenworth T3 & T4 Series
The turbo heat shield mounting could break and cause the steering shaft to jam; this may require extra effort to turn the vehicle
Heavy Vehicle
4 June 2009
REC-003205
active0 ISUZU FX/GX Series fitted w/6UZ1 engine
In some instances the lubrication to the supply pump drive bearing may be insufficient.
Heavy Vehicle
2 June 2009
REC-000371
active2007–2008 HARLEY DAVIDSON FXDSE2
Harley-Davidson Motor Company, Inc. has determined that some of these model motorcycles may have been shipped with an incorrect Australian Noise Label part number 14000-07. The label inaccurately lists 93dbA @ 2675 RPM whereas it should show 99dbA @ 3750 RPM.
Motorcycle
29 May 2009
REC-001554
active2006–2008 ISUZU FV Series
After investigation it was found that due to poor fitment of the oil seal (Gap between the oil seal and needles in the bearing cap) there were some bearing caps where it is possible that a needle could have dropped out during transportation from the supplier in US to the assembly plant Japan. Also a lack of grease applied between the cross pin and the bearing cap was identified. If a vehicle is operated under such conditions, the cross pins may seize in a short period of time. In the worst case scenario the driveshaft universal joint could fail allowing the driveshaft to become disconnected and disable the vehicle.
Heavy Vehicle
27 May 2009
REC-000109
active2008 BMW F800GS
Front-wheel quick-release axles that are not in compliance with design specifications might be installed in some motorcycles. Due to irregularities in the manufacturing process, in isolated cases the quick-release axle might be of reduced wall thickness. Under these circumstances there is a possibility of severe loads on the front wheel (off-roading, for example) causing damage to the quick-release axle. Under worst-case conditions the quick release axle could break.
Motorcycle
26 May 2009
REC-000108
active2008 BMW F800 GS
Front-wheel quick-release axles that are not in compliance with design specifications might be installed in some motorcycles. Due to irregularities in the manufacturing process, in isolated cases the quick-release axle might be of reduced wall thickness. Under these circumstances there is a possibility of severe loads on the front wheel (off-roading, for example) causing damage to the quick-release axle. Under worst-case conditions the quick release axle could break.
Motorcycle
26 May 2009
REC-005322
active0 JAYCO Caravans
Possible cracking on the corners of the coupling plate on the A frame.
Caravan/Motorhome
24 May 2009
REC-003200
active0 Scania 4 Series, G.P.R. T
When examining the clamping joint on the track rod, defects in tolerances and corrosion have been found.
Heavy Vehicle
20 May 2009
REC-000248
active0 DUCATI 848, 1198/S, 1098R Bayliss
Fuel leakage from fuel line at the injector end
Motorcycle
20 May 2009
REC-005323
active2008–2009 Ford LV Focus and MA Mondeo
Under certain conditions, the supply of vacuum to the brake booster may be interrupted. The consequences are possible hard brake pedal with increased stopping distances.
Light Vehicle
18 May 2009
REC-005324
active2008 PEUGEOT 308 Partner
It is possible that the incorrectly specified power steering pump may have been fitted during production. In rare cases this may cause some stiffness in the operation of the steering. Replacement of the electric power steering pump will only be performed if the unit fails the check.
Light Vehicle
10 May 2009
REC-003199
active0 Thule Rapid Fixpoint XT Kit (roof rack)
A faulty hardness of the bolts in the Fixpoint Kits makes them brittle and can cause them to break under stress. The fixation bolt may potentially snap off during use which makes it an unsure load carrier fixation.
Light Vehicle
6 May 2009
REC-003198
active0 Subaru, Rola Subaru SA 098 Roof Bars, Rola Roof Bars
The Roof Bar is designed to anchor to the vehicle by way of securing metal straps or brackets 'Straps'. In product failure cases significant upward wind forces on the under-surface area of the carried loads have stretched or bent the Straps to the point where they detach from the roof of the vehicle. When this occurs there is potential for the Roof Bars and their load to separate from the vehicle during travel.
Light Vehicle
1 May 2009
REC-001472
active2006–2008 Volvo S80, XC70
Volvo Car Corporation have identified a deviation in the CEM (Central Electronic Module) software that may affect the functionality of the windshield wipers. If this condition occurs it may lead to malfunction either through the wipers activating by themselves of they may not activate at the driver's request/command.
Light Vehicle
30 Apr 2009
REC-003203
active0 BUELL 1125R, XB12R, XB12Scg
The motorcycles have a front brake line which may contact the front tyre. The condition could cause a hole to develop in the front brake line, allowing brake fluid to leak.
Motorcycle
28 Apr 2009
REC-003196
active0 Mercedes-Benz Sprinter 906
1. In certain vehicles piston damage may occur as a result of a less than ideal combustion process. If the vehicle continues to be driven in this condition engine oil may be ejected into the engine compartment and could come into contact with hot components. 2. It is also possible the threaded insert for the park brake adjuster may not perform as designed due to an out of specification wall thickness. A failure of this component could result in a loss of park brake effectiveness.
Light Vehicle
22 Apr 2009
REC-005326
active2006–2007 Mercedes-Benz Sprinter Van
It is possible the threaded insert for the park brake adjuster may not perform as designed due to an out of specification wall thickness. A failure of this component could result in a loss of park brake effectiveness.
Light Vehicle
21 Apr 2009
REC-005325
active2006–2007 Mercedes-Benz Sprinter Van
In certain vehicles piston damage may occur as a result of a less than ideal combustion process. If the vehicle continues to be driven in this condition engine oil may be ejected into the engine compartment and could come into contact with hot components.
Light Vehicle
21 Apr 2009
REC-003193
active0 SUBARU Impreza sedan, Impreza hatch
Some genuine towbars fitted to 08MY & 09MY Subaru Impreza vehicles may have been produced with inadequate welding on the tow ball mount (TBM - commonly known as the towing tongue or goose-neck).
Light Vehicle
16 Apr 2009
REC-003195
active0 Heil Asia Tanker various
The design of the handrails of the tankers do not comply with the Australian Standard 1657-1992 (Fixed platforms, walkways stairways and ladders - Design, construction and installation), in particular, the affected handrails have not been designed to withstand the forces required under the Australian Standard.
Trailer
15 Apr 2009