Search Recalls
Search by VIN, keyword, make, or filter by recall type, year, and vehicle category.
Search results
3,634 recalls found
REC-003047
active0 LEXUS IS250, GS300
During the manufacture of two fuel pipes located on the engine's fuel delivery manifold, high stress areas may have been created in the pipes. Combined with other factors such as continual high fuel pressure pulsations and the presence of natural corrosive agents in the fuel a fracture may form over time.
Light Vehicle
29 Nov 2007
REC-003052
active0 HYUNDAI i30
The spare wheel in the FDi30 SX and SLX variants are fitted from factory with a steel wheel and 185/65 R15 tyre. The road wheels on the SX variant are 195/65R15 steel wheels and the SLX is equipped with 205/55R16 alloy wheels. In order to comply with the Australian market regulations, all the affected vehicles will require the 15' spare steel wheel to have two warning labels attached to the outer face of steel rim. The warning labels indicate the spare wheel is for temporary use only at a maximum speed of 80KPH and the road wheel should be replaced with correct size wheel to match the remainder on the vehicle as soon as possible.
Light Vehicle
29 Nov 2007
REC-003054
active0 MITSUBISHI ZE & ZF Outlander
The front edge of the older design genuine accessory carpet mat overlaps the arc of travel of the accelerator pedal. This creates the potential for interference of the carpet mat with the accelerator at the full throttle position.
Light Vehicle
29 Nov 2007
REC-003053
active0 MITSUBISHI NS Pajero
A number of NS Pajero vehicles have been manufactured with the incorrect nuts used to retain the front R/H drive shaft and both front and rear propeller shafts. The threaded portion of the nut may deform on tightening, allowing the nut to become loose in operation.
Light Vehicle
28 Nov 2007
REC-003046
active0 Ford UQ & US Explorer, F Series
In certain circumstances the underhood speed control deactivation switch mounted on the brake master cylinder may leak and brake fluid contamination in the electrical connector may cause the wiring to overheat, smoke, or burn. This condition may occur either when the vehicle is parked or when it is being operated, even if the speed control is not in use.
Light Vehicle
22 Nov 2007
REC-003038
active0 Ford Falcon BFII E-Gas Falcon
The affected LPG tanks may have a service valve hand tap that could fail causing LPG to leak from the hand tap spindle.
Light Vehicle
2 Nov 2007
REC-003043
active0 Mazda Mazda BT-50 4x4 automatic, Hi Rider 2WD
The incorrect Compliance Plate Approval (CPA) number was embossed on the compliance plate.
Light Vehicle
30 Oct 2007
REC-003035
active0 Mercedes-Benz Type 1728, 1830 & 1830LE
Investigations by the manufacturer have shown that there is a possibility the thread profile for the rear axle hub retaining nut may be out of specification, thereby decreasing the retention force acting on the hub nut. A loose hub nut could compromise the integrity of the hub assembly.
Light Vehicle
24 Oct 2007
REC-003040
active0 Toyota Hiace Van TRH201/TRH221 & Commuter Bus TRH223
There is a possibility that the fuel pump may wear prematurely due to insufficient clearance between the coils of the internal motor. If vehicle operation continues in this condition, there is a possibility that the fuel pump could cease to function. In the worst case scenario the fuel pump motor may not operate, preventing the engine from restarting or resulting in the engine stalling while driving.
Light Vehicle
22 Oct 2007
REC-003045
active0 Ford Falcon BFII
The affected LPG tanks may have a service valve hand tap fitted with undersized O-rings.
Light Vehicle
18 Oct 2007
REC-003037
active0 Ford Falcon BFII E-Gas Falcon
The affected LPG tanks may have a service valve hand tap fitted with undersized O-rings.
Light Vehicle
18 Oct 2007
REC-003033
active0 SUZUKI Liana 1.6, Liana 1.8 manual transmission
Due to the shape of the gearshift select lever cable retainer clip, there is a possibility that the clip may impact the gearshift select lever bracket if excessive lateral force is applied when shifting to first gear. If a high frequency of impacts is experienced, the clip may dislodge or even break and the cable may detach rendering the gearshift slect lever inoperable.
Light Vehicle
16 Oct 2007
REC-003032
active0 Toyota Hilux 2x4, 4x4
There is a possibility that the vehicle's engine hood (bonnet) inner panel may crack in the proximity of the striker (part of the retaining latch mechanism) due to prolonged driving on corrugated road surfaces. If vehicle operation continues in this condition, the fracture will extend around the welds of the striker resulting in increasing movement and rattling noise.
Light Vehicle
12 Oct 2007
REC-003031
active0 Toyota Hilux 4x4
Investigations reveal that when Hilux 4x4 GGN25 and KUN26 model vehicles are fitted with a Toyota genuine bullbar (equipped with additional turn signal lights) and are operating a trailer, the vehicle wiring and flasher relay unit capacity is insufficient to operate all the turn signal lamps for the hazard warning function. Individual turn signal lamps (left or right) are not affected.
Light Vehicle
12 Oct 2007
REC-003029
active0 AUDI A6 Avant
In isolated cases the power-operated tailgate on vehicles may close unexpectedly and abruptly, shortly after being opened using the power function.
Light Vehicle
3 Oct 2007
REC-003027
active0 Knorr-Bremse models using Bendix_SR-7 Spring Brake Modulating Valve
07E-038. After prolonged use of the Parker SCV, the valve body retainer may become excessively worn and eventually break apart. Bendix estimates that the wear-through breakage can occur after a year or more service. Parker SCV's manufactured between July 2002 and July 2007 are affected. 07E-037. A component supplier made unauthorized changes to its manufacturing process, which may cause intermittent improper seating in the check valve.
Light Vehicle
12 Sept 2007
REC-002973
active0 APA Manufacturing Axiom Hand taps
LPG liquid could escape from the hand tap spindle, due to undersized o'rings which were provided as part of a faulty batch.
Light Vehicle
11 Sept 2007
REC-000456
active2006-2007 Holden RA Rodeo
The brake master cylinder may have been incorrectly assembled.
Light Vehicle
10 Sept 2007
REC-000568
active0 Honda Civic
A defect relating to vehicle safety exists due to a potential failure of the stop lamp switch, resulting in the stop lamps failing to function when the brake pedal is depressed. The cause of the stop lamp switch failure is an excessive quantity of grease applied to the telescopic steering column mechanism.
Light Vehicle
6 Sept 2007
REC-002948
active0 Mercedes-Benz Sprinter 906
During production of the cable an oversize end lug may have been used which could lead to the positive starter cable separating from the end lug.
Light Vehicle
6 Sept 2007