REC-004581

active

0 TOOWOOMBA FOUNDRY Brake Drums

Category: Heavy Vehicle · Supplier: Toowoomba Foundry Pty Ltd

Recall date: 20 December 1999

Defect

The Incorrect Marking Related To The Maximum Machining Size Cast On The Outside Diameter Of Each Drum. The Maximum Machining Size Applies When The Drum Is Removed From A Vehicle And Re-machined To Restore Integrity Of The Braking Surface.

Hazard

Brake Failure

Remedy

What should you do?

Check your VIN below to confirm whether your specific vehicle is affected.
Contact the supplier — Toowoomba Foundry Pty Ltd — or your nearest authorised dealer to arrange the recall remedy.
Recall repairs are free of charge. The manufacturer or supplier is legally required to fix the defect at no cost to you.
If you have difficulty getting the recall addressed, contact the Department of Infrastructure or your state's consumer protection agency.

Check Your VIN

Enter your Vehicle Identification Number to check if your specific vehicle is affected by this recall.

Source: https://www.vehiclerecalls.gov.au/recalls/rec-004581