REC-000761

active

2017 KAWASAKI ZR900BH

Category: Motorcycle · Supplier: Kawasaki Motors Pty Ltd

Recall date: 3 December 2017

Defect

The holes in the rear shock absorber tie-rod frame mounts could become elongated if the rear shock absorber bottoms out.

Hazard

This may prevent the rear shock absorber from operating correctly and could result in a loss of control of the motorcycle.

Remedy

Consumers are advised to return their motorcycle to an Authorised Kawasaki Dealer to have an inspection and in some cases, have a preventative repair kit fitted to their motorcycle free of charge. In the case that excessive elongation of the tie-rod frame mount is found, a replacement frame will be installed free of charge. For assistance in locating the nearest Kawasaki Dealer go to http://kawasaki.com.au/dealer-locator/

What should you do?

Check your VIN below to confirm whether your specific vehicle is affected.
Contact the supplier — Kawasaki Motors Pty Ltd — or your nearest authorised dealer to arrange the recall remedy.
Recall repairs are free of charge. The manufacturer or supplier is legally required to fix the defect at no cost to you.
If you have difficulty getting the recall addressed, contact the Department of Infrastructure or your state's consumer protection agency.

Check Your VIN

Enter your Vehicle Identification Number to check if your specific vehicle is affected by this recall.

Source: https://www.vehiclerecalls.gov.au/recalls/rec-000761