ISUZU FV Series Recalls
2 recalls affecting the ISUZU FV Series (2006–2010).
2
Active recalls
0
Resolved recalls
2
Total recalls
Buying a used ISUZU FV Series? Check its recall history before you sign.
Paste your VIN into the search page for an instant check on your specific vehicle.
All Recalls
2009–2010 ISUZU FV Series
During the fitting of the Front Underrun Protection Device (FUPD) it has been identified that bolts of insufficient length have been used and the incorrect torque specification applied. This condition could cause steering control to be affected and in the worst case steering control could be lost.
Heavy Vehicle
24 Mar 2010
2006–2008 ISUZU FV Series
After investigation it was found that due to poor fitment of the oil seal (Gap between the oil seal and needles in the bearing cap) there were some bearing caps where it is possible that a needle could have dropped out during transportation from the supplier in US to the assembly plant Japan. Also a lack of grease applied between the cross pin and the bearing cap was identified. If a vehicle is operated under such conditions, the cross pins may seize in a short period of time. In the worst case scenario the driveshaft universal joint could fail allowing the driveshaft to become disconnected and disable the vehicle.
Heavy Vehicle
27 May 2009